Author	[Modern View]
bassndeere 11-18-2012 17:27:12 74.196.186.81 Report to Moderator	I had the same problem when I first started using the HVLP set up. Finally found out that if you run 40/45 going in it will flow good. I also use 3 inline drier's and a gauge on the gun. Might back down on the reducer to 1/2 and use a fast reducer to keep runs down. [Reply]   [No Email]
CNKS 11-19-2012 06:36:12 216.144.104.128 Report to Moderator	Re: PPG Omni questions in reply to bassndeere, 11-18-2012 17:27:12   Some of my HVLP guns say 50 lbs, a couple say 29. You are supposed to use what it says on the gun, or in the info that comes with the gun. There is no need for experimentation, provided it is a quality gun, and in the case of urethane follow the paint instructions exactly. I have never had a problem with one unless it was my fault, not the guns. Cheaper paints such as alkyd enamel are less clear on the ratio. [Reply]  [No Email]