Topic: Re: Opinions before I paint
|Antique Tractor Paint and Bodywork|
[Show Entire Topic] [Return to Forum]
[Show Entire Topic]
[Return to Forum]
[Add a Reply]
I can't recommend phosphoric acid on cast as it gets in the pores. You may want to wash it with soap and water if possible and dry it before you get flash rust. It may take several washings, then use repeated applications of wax and grease remover. Either sand the rust off the sheet metal or use a fiber brush on an electric drill, which is much more effective. It will leave deep scratches that can be partially removed with 150-180 grit sandpaper. If you are afraid of rust use Picklex 20, which acts as a preventative and also gets rust in the pits, if any. It will leave some residue that can be sanded off, then use wax and grease remover. Don't use etch, use two coats of epoxy primer followed by sandable surfacer, which will fill the scratches. Absolutely do not use etch on the cast. The amount of phosphoric acid left will combine with the etch and likely will lift the paint. No I don't use ospho, it is too strong, Picklex is a much better and safer product -- but I don't use it on cast either.
[Reply] [No Email]|
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.|