Topic: Re: 12v conversion - now hard/no start when cold - ytmag kit
|Ford 9N, 2N & 8N Discussion Forum|
[Show Entire Topic] [Return to Forum]
[Show Entire Topic]
[Return to Forum]
[Add a Reply]
Quoting Removed, click Modern View to see
Checked the pulley, and its good... about .060" of clearance between the bottom of the groove and bottom of the belt when tightened. So at least the pulley is good to go, and I must just not have it tight enough. But that can be dealt with.
After talking with dad, he said it used to start pretty reliably down to 0°F a couple years ago... then it started being hard to start without a heater on it. So he had the carb rebuilt by a local guy - and that seemed to fix it... but I tried the other morning when it was about 5° out, and could just get a few hits, and it would never start. Went out yesterday when it was about 50° and no choke, throttle at its lowest setting, and fired up almost instantly...
Any thoughts on getting it to be a bit better at cold starting? I have gone through the carb adjustments like the book calls for, done it a couple ways mentioned on here that I found in searching... and no real change in how it will start cold. (took a few days of dinking to get the different methods tried and they all seemed to end up in the same place as far as screw positions)
Not the end of the world, but Id like to have it as good as it can be before I take it back to dad.
[Reply] [No Email]|
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.|