Author	[Modern View]
heybusdriver 01-11-2013 18:50:44 70.71.96.170 Report to Moderator	I just coated my gas tank with Bill Hirsch tank sealer, I had a pin hole in the bottom , 1st coat the liquid squirted out the pin hole & the tank vent. 2nd coat not a drop came out either, is there a way to clear the vent? or do I have to vent the cap? If I got to vent the cap, what is the best way to do that? By the way , this is the tractor I got in the early summer , had not been run for 26 years , but when I look in the tank, it looked as if it had been boiled clean and the hole soldered, no rust in the tank. Stan 9N 222933 2N with 8N motor 8N345567 8N 146710 8N 179555 8N 197904 8N 199000 8N 254079 8N 362039 [Reply]   [No Email]
heybusdriver 01-12-2013 16:07:27 70.71.96.170 Report to Moderator	Re: venting a gas tank in reply to heybusdriver, 01-11-2013 18:50:44   I just finished painting the tank silver and drilled a hole in the same place it was with a 1/16 drill, looks good. When it warms up I will re-install the tank. Stan 9N 222933 2N with 8N motor 8N345567 8N 146710 8N 179555 8N 197904 8N 199000 8N 254079 8N 362039   [Reply]  [No Email]
Den N Ms 01-12-2013 08:41:47 184.41.137.166 Report to Moderator	Re: venting a gas tank in reply to heybusdriver, 01-11-2013 18:50:44   Drill a small hole in the old cap and install a cotter key in the hole and bend the ends.   [Reply]  [No Email]
soundguy 01-11-2013 19:13:42 107.41.102.121 Report to Moderator	Re: venting a gas tank in reply to heybusdriver, 01-11-2013 18:50:44   drill the cap.. put in a pop rivit.. leave it loose enough to jingle but not come out..   [Reply]  [No Email]
Roger in Iowa 01-11-2013 18:54:43 166.181.82.111 Report to Moderator	Re: venting a gas tank in reply to heybusdriver, 01-11-2013 18:50:44   Vent on my 8N is plugged. Got a cap from NH for a diesel for $20 some. Gas cap was $60+????   [Reply]  [No Email]