|
| |
| Ford 9N, 2N & 8N Discussion Forum |
Topic: Re: 2n with scary noise
[Show Entire Topic] [Return to Forum]
| Author |
[Modern View]
|
| soundguy
01-04-2013 17:40:05
184.245.141.105
|
if no exhaust leak.. read the plugs.. .. then pull one plug wire in turn to see if the knock / slap dies outpost back
|
|
|
| BigDanT
01-04-2013 18:18:41
96.60.16.101
|
|
Re: 2n with scary noise in reply to soundguy, 01-04-2013 17:40:05
|
|
| Tractor has new manifold gasket, don't feel or hear a leak. Pulled plugs,all look the same,clean/tan. Only get the noise after the tractor has warmed up, in gear and pulling some snow. I've tried to get it to knock sitting in the shop but can't. Maybe if I jack it up put it 3Hi ??? I'll try that tomorrow too dern cold tonight...Dan
|
|
|
| soundguy
01-04-2013 18:32:12
184.245.141.105
|
|
Re: 2n with scary noise in reply to BigDanT, 01-04-2013 18:18:41
|
|
| | oil pressure ok? drop any at knock? any possibility you are having a interference issue when hot ? IE.. did you deck the block or shave the head any? i'd think if it was piston slap.. or rod slop.. it would do it more or less constantly unless cyl powered down.. a low op knock might appear at low rpm/pressure.. but yours it at a point pressure should be higher... run her with 3 cyls.. leave 4 out and see if she knocks...
|
|
|
| BigDanT
01-04-2013 19:16:28
96.60.16.101
|
|
Re: 2n with scary noise in reply to soundguy, 01-04-2013 18:32:12
|
|
| Oil pressure good...40 when first started 35 when warm. PO has passed don"t know history but I haven"t been into the engine at all. Will try 3 cylinders this weekend ...let you know. Thanks Dan
|
|
|
| soundguy
01-05-2013 12:44:32
173.104.253.184
|
|
Re: 2n with scary noise in reply to BigDanT, 01-04-2013 19:16:28
|
|
| | post back after observations. good luck!
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
