|
| |
| Ford 9N, 2N & 8N Discussion Forum |
Topic: Re: Float setting 214B
[Show Entire Topic] [Return to Forum]
| Author |
[Modern View]
|
| soundguy
10-27-2012 17:09:58
173.104.119.41
|
the seat has a gasket, and the needle and seat must mate well.float must be set correctly ( .25" ) and not be heavy or hanging up.
|
|
|
| Mr. T. Minnesota
10-27-2012 17:31:27
68.170.114.158
|
|
Re: Float setting 214B in reply to soundguy, 10-27-2012 17:09:58
|
|
| SG,
I recently cleaned the carb completely. The needle and seat are in good condition. I carefully checked the needle in particular looking for grooves and wear. The float is in good condition too. It was not fuel logged and did not show wear. I will replace the gasket with a new gasket. Any other thoughts are welcome!
Mr. T. Minnesota
|
|
|
| old
10-27-2012 17:41:41
4.245.12.21
|
|
Re: Float setting 214B in reply to Mr. T. Minnesota, 10-27-2012 17:31:27
|
|
| If you did not put in a new gasket when you opened up that carb that is likely to be the problem. Gasket once used almost never reseal as they should since they have been squeezed down so can no longer seal as they would have when new
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
