Author	[Modern View]
DrLarryE 09-29-2012 14:38:43 68.60.77.15 Report to Moderator	The main control spring plunger on my 9N sheared off inside the cover. Can this be replaced from the outside? I can't get the pin moved far enough to remove the remaining piece. (First post didn't show up) [Reply]   [No Email]
JMOR 09-29-2012 15:43:04 72.181.173.171 Report to Moderator	Re: Broken Main Control Spring Plunger in reply to JMOR, 09-29-2012 14:38:43   Quoting Removed, click Modern View to seeGoing to need removal. Gasket must be replaces and you couldn't disconnect plunger anyway. Good time to clean out 60 years of dirt from sump, too. Not too major........like a lot of jobs, the dreaded anticipation is a lot worse than the job itself. All of us fear the unknown way too much. No big deal [Reply]  [No Email]
JMOR 09-29-2012 15:08:03 72.181.173.171 Report to Moderator	Re: Broken Main Control Spring Plunger in reply to jackinok, 09-29-2012 14:38:43   Quoting Removed, click Modern View to seeno [Reply]  [No Email]
DrLarryE 09-29-2012 15:36:50 68.60.77.15 Report to Moderator	Re: Broken Main Control Spring Plunger in reply to JMOR, 09-29-2012 15:08:03   Can the cover be lifted just a little easily to replace it, or is a major job to remove the cover to get to it? [Reply]  [No Email]
soundguy 09-29-2012 17:18:44 173.103.217.113 Report to Moderator	Re: Broken Main Control Spring Plunger in reply to DrLarryE, 09-29-2012 15:36:50   before you pull a 9n/2n top cover make sure you disconnect the control fork FIRST.. ;) [Reply]  [No Email]
DrLarryE 09-29-2012 17:54:45 68.60.77.15 Report to Moderator	Re: Broken Main Control Spring Plunger in reply to soundguy, 09-29-2012 17:18:44   I was just reading the step by step in the shop manual. The lift control lever fork is the only internal connection....correct? [Reply]  [No Email]
HCooke 09-29-2012 18:01:37 99.3.166.100 Report to Moderator	Re: Broken Main Control Spring Plunger in reply to DrLarryE, 09-29-2012 17:54:45   Yes [Reply]  [No Email]