Author	[Modern View]
Michael priar 09-03-2012 12:00:42 174.238.199.63 Report to Moderator	Hi guys, how do i get this bearing off, it needs to be replaced. Thanks fo the help. [Reply]   [No Email]
TheOldHokie 09-04-2012 05:31:00 108.8.18.170 Report to Moderator	Re: transmission input bearing in reply to BIG_EASY, 09-03-2012 12:00:42   Michael priar said: (quoted from post at 19:39:29 09/03/12) Sorry about that, 51 8n, putting in a sherman with a bad input shaft, going to replace the bearing with one i can get a race for, so the race can be put into the sherman shaft, unless someone knows where i can get a race for the original bearing. I was told by the machine shop that a race was not available for that bearing. Thanks If I understand you correctly the reason the shop told you a replacement race for the input shaft bearing (p/n 7120) wasn't available is because it is integral to the input shaft (p/n 7017). See picture below - the race is ground into the face of the gear on the end of the input shaft. How are you planning on replacing it???? When that race is damaged the entire shaft is toast and has to be replaced. Not one of Ford's better ideas..... TOH This post was edited by TheOldHokie at 06:42:14 09/04/12. [Reply]  [No Email]
Bruce (VA) 09-03-2012 12:10:00 24.125.80.178 Report to Moderator	Re: transmission input bearing in reply to Michael priar, 09-03-2012 12:00:42   It would be helpful if you would tell us what it is you're working on. 50 Tips [Reply]  [No Email]
Michael priar 09-03-2012 16:39:29 174.253.2.222 Report to Moderator	Re: transmission input bearing in reply to Bruce (VA), 09-03-2012 12:10:00   Sorry about that, 51 8n, putting in a sherman with a bad input shaft, going to replace the bearing with one i can get a race for, so the race can be put into the sherman shaft, unless someone knows where i can get a race for the original bearing. I was told by the machine shop that a race was not available for that bearing. Thanks [Reply]  [No Email]