(800) 853-2651
SHOP NOW

Did MM ever use a big

F

fastfarmall

Well-known Member
Hi guys, did MM ever use a wide fender on a R or Z, there wide like a Case Standard Tractor,but these have a little triangle tool box, near the bottom ,back side,and one has a rope trip, holder or a clip, that i never have seen before, I been told before long time ago,that they are ford fender's? But these are yellow!!!
 
R only had the flat vertical fender until 50's when had small clams. Z used flat top one early model standards and crown on universals. Later Z only had small clams then ribbed ones. No big wheatlands like on U or G.
 
The only place I have ever seen the fender you describe with the tool box at the lower rear was on a Fordson. Back in my childhood (When 'old tractors' were pretty much Fordsons and McCormicks, there were a few around here. I don't think I have seen one at a show in several years.

They may have been aftermarket offerings for the Fordson. Lots of other manufacturers offered 'improvements' for Fordson tractors as the tractor itself was pretty basic.

That does not mean you havent seen them on a MM. A lot can get changed or swapped in 75+ years on these old tractors.
 
You must log in or register to reply here.

Similar threads

J
Pick a welder
2
Replies
37
Views
2K
fastfarmall
F
M
New-to-me JD-A and JD-B Repair Tips
Replies
13
Views
789
Fixingfarmer
Fixingfarmer
cpratt
I can't tell what I've already read?
2
Replies
32
Views
1K
Rich'sToys
R
M
Ford 4000
Replies
11
Views
1K
showcrop
showcrop
V
new owner of a 620, will try to update this as we go.
2 3 4
Replies
61
Views
3K
valiant8086
V
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top