4020 Clutch adjusting tool

jsborn · Sep 9, 2013

Does anyone have the dimensions for the JDE - 19 Clutch finger adjusting tool.

I am in need of one and can machine my own if I can find a drawing with dimensions on it. I sure hate to buy one for what is to be a one time use (I hope) :lol:

Thanks

Mike M · Sep 9, 2013

I was able to go to my local dealer and laid it on a piece of paper and traced around it. I then made one from the tracing. Doesn't the I&T manual give the dimensions ?
I don't have any of this stuf anywhere near me at this time.

jsborn · Sep 9, 2013

The I&T Manual I have gives the dimensions for the line up shaft but not the adjusting tool. At least I have not found it

:?: :?:

Tx Jim · Sep 9, 2013

YT tractors parts has one for sale At upper LH corner of this page.

Tx Jim · Sep 9, 2013

edit double post

jsborn · Sep 9, 2013

Yes I saw that Tx_Jim but I was/am trying to save that $60 plus shipping by doing a little machine work in the shop and making my own.

jsborn · Sep 11, 2013

With my reading I have found that the JDE-19 tool has changed to the JDE-61 tool .

I do have a lead on one that I can measure up to make one and If I get the measurements I will post them.

jsborn · Sep 12, 2013

Thank you everyone for all the information on where to buy these tools but as I stated in the OP what i wanted is the specs./measurements for them so I could make one.

I talked with my local JD shop yesterday and they offered to loan me their tool when I need it so I guess when i get it I will measure it up so I can make one later.

If anyone has the Specs./Dimensions I would still like to have them.

Thanks again to everyone's help.

jsborn · Nov 15, 2013

This is what I found and I hope it helps someone else.

4020 Clutch adjusting tool

jsborn

Member

Mike M

Well-known Member

jsborn

Member

Tx Jim

Well-known Member

Tx Jim

Well-known Member

jsborn

Member

jsborn

Member

jsborn

Member

jsborn

Member

Similar threads