4020 3 point

Bob C IL · Oct 9, 2012

Top syncro shaft went out on my 4020 all is fine eccept 3 point dont work right... had to remove top of rear end but no other hyd, work. pretty sure draft control lever inside was up any ideas?? Bob Clark 217 712 0984 this is a fender control model.

Tx Jim · Oct 10, 2012

Have you tried moving the L/D lever under the seat to a different setting? It's possible that L/D mechanism inside tractor needs adjusting. There are several steps outlined in the JD tech manual that require checking to set correctly.

tim s · Oct 10, 2012

Re-check the draft control cam follower, you can do this by lifting the control valve off the rock shaft,,my bet is it is not in place,,Darn it

4020 3 point

Bob C IL

New User

Tx Jim

Well-known Member

tim s

Well-known Member

Similar threads