4020 DRAWBAR SUPPORT UPDATE

TIMAR · Mar 27, 2010

Got it back from the machine shop yesterday. Looks very good. I had them put a bushing in each outer draft link hole. The inner ones were not worn that bad. I used the same bushing as the lower drawbar pin uses. It is just over an 1" in dia.

Anonymous-0 · Mar 28, 2010

if you would look in the parts book you will find the pins for lower pull arm on 3 point are 2 differnt sizes on the same pin the head is larger to fit in the souport without a bushing

TIMAR · Mar 28, 2010

Not sure what you are talking about. I have new pins and they are the same dia. the whole length. Maybe I'm looking at the wrong part.

M w J · Mar 28, 2010

The head of the pin is 1.25 in diameter and the rest of the pin is just less then an in. the head of the pin fits into the casting where the bushing is now . Pin part no. is r26609. Is the new pin you got long enough now The head of the pin should be 1 in. long and 1.25 dia.

TIMAR · Mar 29, 2010

The part no. I got is R42452 which is replaced by R53558. Head dia is 1.5 body dia is .995.
I am talking about the draft arm pins, not the drawbar pin.

4020 DRAWBAR SUPPORT UPDATE

TIMAR

Member

Anonymous-0

Well-known Member

TIMAR

Member

M w J

Member

TIMAR

Member

Similar threads