Author [expand]	[Modern View]
kent robertson 10-27-2009 16:48:19 76.111.135.9 341215 Report to Moderator	i need to figure out why when i go to hook this brown wire up to the solenoid it archs really hard. maybe the ignition switch is bad causing the two 12 volt sides to short together. I hate to just replace parts. [Reply]   [No Email]
mlauk 10-28-2009 08:37:36 66.196.205.180 341277 Report to Moderator	Re: jd 4010 diesel 24 volt elect. problem in reply to kent robertson, 10-27-2009 16:48:19   Remove the solenoid, take it apart and see if it has arced/melted the contact points. Low batteries will cause this.   [Reply]   [No Email]
buickanddeere 10-27-2009 18:58:03 216.183.148.98 341236 Report to Moderator	Re: jd 4010 diesel 24 volt elect. problem in reply to kent robertson, 10-27-2009 16:48:19   Check with a ohm meter to find the short to chassis from the brown wire.   [Reply]   [No Email]
kent robertson 11-04-2009 15:20:00 76.111.135.9 342068 Report to Moderator	Re: jd 4010 diesel 24 volt elect. problem in reply to buickanddeere, 10-27-2009 18:58:03   i checked for continuity between brown wire and chassis, there is none, had starter checked and they put new solenoid on but still has short. maybe the generator has a short inside. i checked the rubber isolator that the regulator is mounted on and there is no short to chassis there, guess the ignition swithh could be bad also, im lost   [Reply]   [Send Email]