Author	[Modern View]
david legge 03-07-2013 08:43:12 216.96.88.63 Report to Moderator	need manual or diagram for a 1953 jubilee hydraulic pump [Reply]   [No Email]
Kurt-NEPA 03-07-2013 12:51:43 70.44.176.213 Report to Moderator	Re: hydraulic pump in reply to david legge, 03-07-2013 08:43:12   Do you have a round piston pump or a square vane pump? If you have the later round piston pump, I can email you some info. If its a vane pump, good luck, parts are not available. Like George said, the round pump seal wears a groove in the wobble shaft and causes a suction side air leak. That and broken/worn springs seem to be the most common problems. Parts are available for a full rebuild. But, Replacing that seal not a job for a newbie or poorly equipped mechanic. If you want to give it a try, we can help. [Reply]  [No Email]
George Marsh 03-07-2013 12:04:15 50.104.195.160 Report to Moderator	Re: hydraulic pump in reply to david legge, 03-07-2013 08:43:12   david legge, A few years ago, I rebuilt a 600 series piston pump on my Jubilee. I ordered every part I could find from YT or fix-a-ford. The seal wears groves in the wobble shaft so, I replaced it. One of the hardest things was pressing the bearing on the wobble shaft, even though I have a 20 ton press. Next time I won't buy a new shaft, instead I'll just replace the seal. If you don't press the seal in all the way, it will rub on a different part of the shaft. I think you will need to remove the race to get to the seal. To do that, I welded a washer to the race and it almost fell out. I think you can purchase just a race without the cone bearing. I found out the reason my pump was loosing prime, it had a broken spring. George [Reply]  [No Email]
DGinVT 03-07-2013 11:46:12 75.105.0.53 Report to Moderator	Re: hydraulic pump in reply to david legge, 03-07-2013 08:43:12   For the FO-19 Ford manual try "jensales" in Minn or else get your local newholland/ford dealer to order one for you. I don't remember the cost but they are worth their money. [Reply]  [No Email]
soundguy 03-07-2013 11:13:24 184.240.165.178 Report to Moderator	Re: hydraulic pump in reply to david legge, 03-07-2013 08:43:12   here's a close one for the piston pump.. notice the plumbing in the inset pic... should be a vane pic next.. [Reply]  [No Email]
Ultradog MN 03-07-2013 09:01:17 174.20.239.40 Report to Moderator	Re: hydraulic pump in reply to david legge, 03-07-2013 08:43:12   I don't know of any place online to find one. Try Ebay for an FO-19 Here [Reply]  [No Email]