Author	[Modern View]
agtrac 11-13-2012 18:16:18 67.239.15.62 Report to Moderator	Hey everyone, I've got a 7810 S that started out with the pto not disengaging, I pulled the lift cover and found the brake band broken so I decided to take the clutch pack and valve assembly out to inspect everything, I found worn clutches and valve support arm seals worn etc so I replaced the clutches and drum, the support arm and valve, put everything back together and now the pto shaft wont turn under a load, any ideas what can be causing this, it feels like I have no hydraulic pressure but all the other hydraulics work fine, I'm at a loss... [Reply]   [No Email]
Bern 11-13-2012 18:25:21 66.218.203.16 Report to Moderator	Re: 7810 pto problem in reply to agtrac, 11-13-2012 18:16:18   I'm guessing that you did not get the pressure pipe clipped in place good. However, this would also affect the dual power as well. [Reply]  [No Email]
RodInNs 11-13-2012 19:23:25 216.118.158.123 Report to Moderator	Re: 7810 pto problem in reply to Bern, 11-13-2012 18:25:21   Or he didn't get the shaft fully seated in the clutch pack... or the correct torque on the support arm locator screws for the clutch. Most likely the supply line tho. Rod [Reply]  [No Email]
agtrac 11-14-2012 14:53:45 67.239.15.62 Report to Moderator	Re: 7810 pto problem in reply to RodInNs, 11-13-2012 19:23:25   thanks guys for your replies and your help, but found out that the tractor serial number on the frame says its a 7810 but its actually a 7810S so the new clutch pack valve was wrong, got the correct one on order and should solve my problem... [Reply]  [No Email]