|
| |
| Harry Ferguson Tractors Discussion Forum |
Topic: Re: 134 piston direction?
[Show Entire Topic] [Return to Forum]
| Author |
[Modern View]
|
| PackardV8
01-21-2013 06:09:25
64.12.116.73
|
General engine buiding practice REGARDLESS of what kind, type or manufacture of the engine:
When no conspicuous marks are on the piston (or even when there is) the bible is to check for WRIST PIN OFFEST. The wrist pin must set closest to the THRUST side of the cylininder wall in ANY engine. The thrust side of the cylinder is the side of the cylinder that the ROD JOURNAL passes under FIRST when engine is turned in it's appropriate direction. IN this cae of the Cont engine for the Ferguson tractor it would be the rite side of the cylinder (nearest brake pedal, or exhaust/intake manifold).
SOme pistons may or may not have pin offset. If no offset then should make no difference except in the case of T-slotting or other characteristics usually spelled out by a service manual.
Most likely REPOP pistons WILL have pin offset because most likely such repop pistons are simply CLONES of some other more main stream current production piston.
CHECK FOR PIN OFFSET!!!! IF u find offset then u mite want to contact the supplier and let them know that the pistons have offset pins. Probably a 80% chance the supplier has no idea. I've gotten into this too damned many times.
This post was edited by PackardV8 at 06:21:49 01/21/13. |
|
[Reply] [No Email] | |
| Tony in Mass.
01-21-2013 06:30:20
76.127.225.182
|
|
Re: 134 piston direction? in reply to PackardV8, 01-21-2013 06:09:25
|
| So, if the offset isn't obvious, then you'd have to balance one on an inspection table and dial indicators?? I know some pistons have a specific direction because of valves or oil slots, but - yep, generic repops is a good discription.. an arrow would be nice tho... |
[Reply] [No Email] | |
| Jason S.
01-21-2013 15:37:50
174.252.145.163
|
|
Re: 134 piston direction? in reply to Tony in Mass., 01-21-2013 06:30:20
|
| Tony, I measured two of my Z120 pistons just now, one of the old ones and one of the new ones and neither one of those had offset in the wristpin. So you should be fine, but it never hurts to double check yours if you want. |
[Reply] [No Email] | |
[Show Entire Topic]
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|