(800) 853-2651
SHOP NOW

Adjusting Valves

L

Lucid

Member
Yesterday I tried asjusting the valves on my 200. Did #1, but had a hard time doing the rest. Couldn't crank it even enough to land right. Is there any tricks to help me out? Pull all the plugs out? Can I adjust cold? Thanks for any help.
 
yes have plugs out. if doing cold have to add an extra .002 to the spec. best to warm it up remove valve cover and plugs the adjust. firing order is 1342 so that is the order to adjust cyl's. you actually watch each cyl's running mate . meaning once cyl. #4's valves are rocking ( one valve is closing and the other is just opening)that means #1 cyl. is on tdc of compression and ready to adjust. the to adjust #3 cyl. watch #2 cyl. valves to get them on the rock, and do this for the other 2cyl's till done.i always give the engine on last roll over with a final check.
 
Thanks everyone, got them adjusted. I had a hand crank, but got aggrevated at it hanging out toolbox one day. Put it somewhere unknown to me now!
 
You must log in or register to reply here.

Similar threads

W
Farmall A hard starting - fueling issue
Replies
14
Views
625
C.Amick
C
Slow lane 49
350 utility belt change
Replies
6
Views
459
Slow lane 49
Slow lane 49
W
Hydraulic Drive Problem
Replies
8
Views
607
wgraves
W
J
I Harp & Harp But It Happened Again!!
2
Replies
25
Views
2K
cushman
C
P
350 U. Rethinking the 1 way power steering
Replies
3
Views
297
Janicholson
Janicholson
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top