Charlynn for Super M-TA

Rex Simpkins · Feb 20, 2015

I have the item home and looking at putting it on when the weather gets a little warmer. So all I need to put this steering unit on my M-TA and use the factory Hydraulics is a priority valve that will lower the pressure down to the orbit motor(correct?) I see one's for sale at a few tractor sites just for these applications. One inlet one outlet, outlet goes to power side of orbit motor(correct?) and then outlet side of orbit motor goes back to tractor tank ? Does anyone use or have used these priority valve and if so where did you place it on the tractor. I have looked at a few photos but they looked like adjustable priority valves.

Paul A Young · Feb 20, 2015

Three holes on the priority valve 1- pressure supply in 2- pressure out to orbit motor 3-bypass out back to tank.Orbit motor needs #2 pressure in and out goes back to tank. Priority valve can be put on pressure line coming from pump to hyd. box usually. I just put one on my SM-TA on pressure side of hyd. box because I did not need the single action ports on box. I am using a dual valve with pressure relief built in before oil gets to hyd. box to run three point and dual acting remote .Remember two things 1 you have to have the bypass on priority valve back to box and 2 your lever on hyd. box needs to be locked engaged if you use the pressure port on box. Hope this helps ,Paul

Rex Simpkins · Feb 21, 2015

Gotcha thanks for the reply

Charlynn for Super M-TA

Rex Simpkins

Member

Paul A Young

Member

Rex Simpkins

Member

Similar threads