farmall C- 133 cu. in. carb. ?

showdown · Feb 4, 2015

If I replace my zenith carb. on my c-133 how big of a carb. can I put on it, and what would had be?

gene bender · Feb 4, 2015

What makes you think you even need a different carb.

showdown · Feb 4, 2015

for pulling

Shaggy · Feb 4, 2015

You can use the carb you have.
You may have to open up the venture a little and drill the main jet a few sizes bigger but if you do that make sure you have a adjusting needle so you can lean it out if you go to big
I tapered the inlet (air cleaner side) up to the choke butterfly also.
What have you done to you 133?

showdown · Feb 4, 2015

How about the carb on a c-135 lile say f 340

old · Feb 4, 2015

With out doing things inside the engine a larger carb will not help much if any at all. Now if the carb you have does not have an adjustable main jet then going to a bigger jet may get you a bit more but probably not enough to make a difference

Shaggy · Feb 4, 2015

I have been told they have a little bigger inlet which would help.
If it will bolt to your manifold I would give it a try!
What manifold are you using?

Dblair · Feb 4, 2015

If you have the same cu.in and not a higher compression rate that would be a good carb . if your compression is a lot higher you may need more carb. I ajust mine on a dyno .

kub6040 · Feb 4, 2015

The carb. from a 424 gas or 504 maybe more than you need but you can try it. The 424 gas has a C-146.

400Dtractorman · Feb 14, 2015

We have that motor in a BN with 4 1/4 pistons. We are using a WD carb.

farmall C- 133 cu. in. carb. ?

showdown

Member

gene bender

Well-known Member

showdown

Member

Shaggy

Member

showdown

Member

old

Well-known Member

Shaggy

Member

Dblair

Well-known Member

kub6040

Well-known Member

400Dtractorman

Member

Similar threads