Super C distributor

Anonymous-0 · Sep 15, 2014

Getting my motor for the Super C wrapped up. The small gear on the end of my distributor is heavily worn, as is the gear/shaft that goes into the governor. I ordered both replacements this morning. How do I get the old distributor gear off? There is a small screw on the side of the distributor that would use a flat-head screwdriver but it is all rounded off. My other thought was through the top, under the distributor cap. Before I start damaging anything else, what is the correct way?

Owen Aaland · Sep 15, 2014

The gear is held on the distributor shaft with a pin that is riveted in place. I usually just use a piece of the correct size (1/8"?) welding rod for a new pin.

tractorguy2 · Sep 16, 2014

That small screw is where you grease it.

Super C distributor

Anonymous-0

Well-known Member

Owen Aaland

Well-known Member

tractorguy2

Well-known Member

Similar threads