Farmall 504, C153, Super C question

Rex Simpkins · Jul 3, 2014

I have my Super C broken down and getting things ready to go back together. I see that the 504 flywheel has a bearing in it but the CaseIH parts breakdown do not show the bearing seperate.

Can anyone who has replaced one tell me what bearing # they used and can anyone who has put a C153 in an "A" "B" "C" 140, 130 tell me what bearing they use in the original flywheel

gene bender · Jul 3, 2014

Bearing doesent go in the flywheel it goes in the crankshaft its a brass bushing. A,B,andC,SC use the same i dont know what the other cranks use. You would need to measure the input shaft to see if they are different.

Rex Simpkins · Jul 3, 2014

Can not use a pilot bushing with the C153 engine unless you bore the crankshaft---not going to do that, so only option is bearing or bushing in flywheel and cut down drive shaft. A few folks on here have done this change and hope they remember what bearing they used, or what the bearing # in the 504 flywheel is

But thanks for the input

Bob · Jul 3, 2014

504 pilot bearing is IH # ST553, SKF #6204-2ZJ
Key 8.

gene bender · Jul 3, 2014

I talked to a guy who used a drill on the crank for a pilot bearing on that engine said it worked out just fine.

Rex Simpkins · Jul 3, 2014

Thanks

Farmall 504, C153, Super C question

Rex Simpkins

Member

gene bender

Well-known Member

Rex Simpkins

Member

Bob

Well-known Member

gene bender

Well-known Member

Rex Simpkins

Member

Similar threads