This is a picture of inside my
bellhousing. I have already installed the
kit I bought from Ag Parts LTD, but I had
1 large o ring left over. My 400 service
manual says it should go on the bearing
retainer in the picture, but there was no
groove anywhere for it to fit. I did
install the large o ring in the rear of
the TA, so I think I would know what to
look for. I want to make sure its done
right before I reassemble it.
bellhousing. I have already installed the
kit I bought from Ag Parts LTD, but I had
1 large o ring left over. My 400 service
manual says it should go on the bearing
retainer in the picture, but there was no
groove anywhere for it to fit. I did
install the large o ring in the rear of
the TA, so I think I would know what to
look for. I want to make sure its done
right before I reassemble it.