(800) 853-2651
SHOP NOW

super c single front

K

kub6040

Well-known Member
Ok, the best I can tell there are 2 single fronts for sc,c,etc. i have a 600x12 but have found 750x10 do they fit the same fork ? Any help is appreciated.
 
The two sizes use a different fork - the 6.00X12 uses fork p/n 52950DA while the 7.50X10 uses fork p/n 57895D. The wheel for a 6.00X12 is a one piece wheel p/n 8333D while the 7.50X10 wheel is made up of two halves (p/n's 5630DAX and 5631DAX) which are bolted together to make the wheel. I obtained this information from my TC-53 part catalog for the 200, 230 & 240 model tractors. In looking at my TC-44B Super C part catalog the same noted forks and wheels were used on that model as well. HTH, Hal.
 
I HAVE 2 OLD TRACTORS FROM UNDER COTTON PICKERS. THEY HAVE THE SINGLE WHEEL AND FORK. ONE IS A 9.00X 10 BOLT TOGETHOR WHEEL. THE OTHER IS A 6.00 X 12 SOLID WHEEL. I WOULD BE CAREFUL IN INVESTING IN THESE ITEMS. THEY DO NOT HAVE BEARINGS,THEY HAVE COPPER SLEEVES, AND YOU CANNOT BUY ANY PARTS FOR THESE WHEELS. I WOULD SUGGEST A TRI-CYCLE FRONT END. MUCH CHEAPER IN LONG RUN. I ALSO HAVE A TRI-CYCLE THAT WILL FIT. I LIVE IN ARKANSAS IF CAN HELP.
 
You must log in or register to reply here.

Similar threads

M
Farmall C/Super C Liftall Differences?
Replies
2
Views
314
Harold Hubbard
H
M
Super C Carb Identification
Replies
4
Views
274
mainer76
M
M
Searching for Super C Shafts
Replies
11
Views
678
Bull Gear
B
R
Super C disc brakes
Replies
11
Views
387
Levi81
L
M
Super M transmission shaft seal
Replies
7
Views
231
Mark Poss
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top