W4 trans seal

toymaker 27 · May 20, 2014

I just reassembled a W4 only to find that one of the new gaskets at the throwout bearing end of the transmission is leaking oil. Is it possible to change these gaskets without either splitting the tractor or pulling the motor? I am about to remove the fuel tank, belt pully housing and the clutch cover that holds the starter, (iam sure there is more that needs to come off) I had the surface of the imput shaft re machined to elininate groves and have put in new seal.

Duane Rushlo · May 20, 2014

you get what you are taking off . just unbolt clutch shaft pull yoke off front trans

W4 trans seal

toymaker 27

Member

Duane Rushlo

Member

Similar threads