(800) 853-2651
SHOP NOW

Looking for rear axle washer for International 240

C

cleb

Member
10322727_693970153983256_708528528334847002_n.jpg


We had the rear wheel come off our International 240... no one was hurt but we need the washer that holds the dished wheel to the axle and the bolt...

The bolt is generic so if needed we can get one at the parts store... but the washer is probably a bit beefer then a fender washer... so far we have not been able to find a part number or the part...

Anyone have any ideas where to get one?

thanks

14242005333_b2f372f8b5.jpg
 
Certainly an unfortunate event and glad no one was injured. You might be able to obtain the part from your local CaseNH or CaseIH dealer (whatever their correct name is today) as it is listed in Messicks on-line IH catalog with a $6.52 price with none in stock. You can call Jeannie Hershey at 1-eight hundred two two two 3373 to order one from them if desired. Best of luck in resolving your situation, Hal.
 
Thanks everyone... I don't have a lathe so I'll be calling IH today... would like to get her back out of the field... just put a new carb and new points in her... she was running better then she has in years...

I actually went back into the video I shot for my youtube channel going over the carb swap and sure enough

14035170399_6ba46c725d_c.jpg


it was staring right at me and I didn't see it...
 
(quoted from post at 17:24:54 05/19/14) And be sure to torque the bolt to spec and check the other one.
Click to expand...

you know it... hate to have that happen twice...

Now the big question in my head is how long has the bolt been gone... 6 months... a year...

thanks again
 
thanks everyone I got the tractor back up on all fours... it wasn't to bad... if it weren't for how wet it has been it would have been easy... ground kept on settling under the jacks and cribbing...

I did a little time-lapse of the whole process if anyones interested...

http://www.youtube.com/watch?v=n6fv6Tsk6-Q

thanks again
 
You must log in or register to reply here.

Similar threads

C
  • Question
Dished Rear Rims
Replies
3
Views
348
cleddy
C
J
Remove rear axle hub
Replies
15
Views
702
JohnAndrew
J
R
1030 rear axle
Replies
3
Views
548
used red MN
U
D
Deere 2020 rear wheel pinion bolt
Replies
4
Views
250
JIM MN
J
T
Case-IH 895 steering question.
Replies
15
Views
443
Texasmark
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top