(800) 853-2651
SHOP NOW

Center pivot pin in front axel 86 series

L

Larry B. 1486

Member
My center pivot pin thru my front axel on my 1486 refuses to take grease. I have changed the grease fitting, squirt WD40 in it, used a grease buster and it just won't take grease. I have had to pull the pins on my old 806's and 856 before to clean out the grease hole in the center of the pin but never pulled on out on a 86 series before. Can anyone tell me what holds it in and how the pin comes out. Does not look like to me that it will come out the front. Any information appreciated.
 
Did you try lifting the front to relieve pressure on the grease port at the bushing. It might give it a fighting chance. Jim
 
There is or should be a 5/16 bolt about 6" long thru the pin from side to side on the big front cast piece.

If there is no bolt in the holes on the side of that cast piece then the bolt sheared off. It should drive right out with that bolt removed.

Jack the front up just enough to get the pressure off the pin first.

Gary
 
If you have the latest one piece casting you may have to disassemble a few more things. On the older style, not so much,. Fact is, some used to work out on their own, not good. Actually, I have had quite a few older styles out but don't really remember the exact procedure.
 
You must log in or register to reply here.

Similar threads

S
Lubing The 885's Front Axle Pivot Pin
Replies
3
Views
210
ScottNC
S
S
Home Brewed Align Bore For Front Axle Bushing
Replies
11
Views
699
ScottNC
S
M
pulling the front axle pivot pin in a MF245
Replies
5
Views
418
stevieb49829
stevieb49829
TractorDad3
4-cylinder 4000 front pivot pin wiggle
Replies
7
Views
241
TractorDad3
TractorDad3
O
Wear on Front axle pivot
Replies
11
Views
925
onetotaltoolman
O
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top