F20 rod bearings

Anonymous-0 · Feb 19, 2014

How tight should the nuts be tightened on the rod bolts? I see there are castle nuts to put a cotter pin thru the end. I thought one of my manuals would give a # rating but I can't find anything.

Nebraska Kirk · Feb 19, 2014

There is no torque spec for the rod bolts. Run them down firm and then a little more until the holes line up so you can put a cotter pin through.

Stemmy · Feb 19, 2014

(quoted from post at 15:48:27 02/19/14) There is no torque spec for the rod bolts. Run them down firm and then a little more until the holes line up so you can put a cotter pin through.

or better yet use some stainless safety wire in place of cotter pins

rustred · Feb 19, 2014

they are for cotter pins. stainless wire is not that fat. cotter pins are easy and neat.

F20 rod bearings

Anonymous-0

Well-known Member

Nebraska Kirk

Well-known Member

Stemmy

Member

rustred

Well-known Member

Similar threads