Super A Poor Acceleration

CGID · Jan 21, 2014

I've checked the spring in the governor housing and it is intact. It starts easily but woun't rev much past idle. What else?

Oldiron29 · Jan 21, 2014

Truster bearing on governor shaft. If there is play in governor fork you will not pull spring enough to open carb. oldiron29

ken house · Jan 21, 2014

chock the wheels, start the motor, stand beside carb and try moving the gas feed lever by hand.

Janicholson · Jan 21, 2014

The other ideas are fine. I would start with the linkage from the hand lever to the governor. It should provide a full travel to the governor input lever as the hand lever moves from idle to full throttle. If not make it so. The linkage can be disconnected at the governor and moved by hand to assure it is in the governor, and not the operator side linkage. Jim

gene bender · Jan 21, 2014

Your input shaft from the throttle must wobble bad and the linkage to the carb needs attention to see if its correct.

Super A Poor Acceleration

CGID

Member

Oldiron29

Well-known Member

ken house

Member

Janicholson

Well-known Member

gene bender

Well-known Member

Similar threads