cylinder sleeve issue

ziemerj · Jan 12, 2014

I'm working on a tractor and one of the cylinder sleeves is stuck I believe it has sleeve retaining compound holding it in. Is there a way to get that freed? Thanks for your help.

Janicholson · Jan 12, 2014

Help us give a best solution answer, tell us what tractor/engine it is. Jim

Jziemer · Jan 12, 2014

Its a 560 with the 282 diesel.

Nebraska Kirk · Jan 12, 2014

That sleeve retaining compound breaks down when it gets hot enough, hotter than a running engine gets. Take a torch and run around inside the sleeve heating it up some, but not red hot.

Jay Snyder · Jan 18, 2014

Using a puller? Or trying to do it without? Heat up the sleeve a little and usually with a "slight" amount of force they slide out. Guessing the retainer is gone out of the block bore but could of got a little rust in it and rusted the sleeve in the block. Good luck.

cylinder sleeve issue

ziemerj

Member

Janicholson

Well-known Member

Jziemer

Member

Nebraska Kirk

Well-known Member

Jay Snyder

Member

Similar threads