Farmall H Sleeve Puller

Brady Miller · Jan 7, 2014

Gents,

Looking for a sleeve puller puck for my H to pull the sleeves. What is the OD of the new or old sleeve to be installed. I understand the 3 3/8" std bore sleeve and the 3 7/16" overbore sleeve. What is the OD of the sleeve?

Thanks,

Brady

El Toro · Jan 7, 2014

Can you measure the cylinder bore diameter of the block with the old sleeve installed? You may be able to measure the block bore after removing the piston and connecting rod. If the sleeve doesn't extend all the way down to the bottom of the block. Hal
PS: Use a pair of dividers to get a close measurement.

rustred · Jan 7, 2014

you could measure it at btm with calipers if possible. puck has to be a few thou. smaller than the o.d. of sleeve. I just take an old sleeve to the machine shop and they build the puck to fit.
100.00 dollars later you have one.

El Toro · Jan 8, 2014

Contact Federal Mogul tech service at 1-800-325-8886. They may know what the block bore is for the H. Hal

Dave S. · Jan 8, 2014

Measured bottom of 3 7/16 sleeve taken out of H. OD 3.560
ID 3.439

caterpillar guy · Jan 8, 2014

If you have the new sleeves just measure that then reduce by a few thousandth"s. should get the job done.

Brady Miller · Jan 8, 2014

Thanks

Farmall H Sleeve Puller

Brady Miller

Member

El Toro

Well-known Member

rustred

Well-known Member

El Toro

Well-known Member

Dave S.

Member

caterpillar guy

Well-known Member

Brady Miller

Member

Similar threads