ih 966 hydrulic leak

jordan watson · Jan 4, 2014

My 966 has developed a hydrulic leak under the tractor. The best I can tell it's coming from what looks like an inspection plate where the engine and trans go together. It's a steady stream not just a little drip. thanks jordan

the tractor vet · Jan 4, 2014

Probably the seals in the PTO input shaft . And if you are running the trans -rearend over full is not helping . Now as to why this started ???? but it could be caused by the IDPTO bearing going bad and may be the shaft it's self is about ready to strip out and leaving you high and dry . She will need split at the bell housing to repair and while your there look real hard at the spines in the pressure plate and the IDPTO shaft.

catman13 · Jan 4, 2014

if the motor has a lot of hours on it i would replace the rear main seal on the motor while you are in there, because it will start leaking after you get it back together just four fun

MikeinKy · Jan 5, 2014

My 766 did that last year and I split it and replaced the seals on the trans input shaft.

ih 966 hydrulic leak

jordan watson

Member

the tractor vet

Well-known Member

catman13

Member

MikeinKy

Well-known Member

Similar threads