(800) 853-2651
SHOP NOW

super a waterpump addition

P

pork

Member
im wondering if I can put a waterpump from a c- farmall onto a super a. are they the same engine. what will I need, or is this even do-able.
 
When I overhauled my B farmall years ago a water pump was installed. The head gasket should be replaced also as water pump equiped engines use a different gasket. The B does not get hot with the six foot Woods mower now like it did before it was rebuilt.
 
Yes. Get one for a Super C and it will bolt right on the lower water inlet. Get the Super C fan belt too.
 
Why change headgaskets as the hole in the head and block are the same. Of all those engines i have worked on the replacement gaskets are the same so realy the gasket wont make any difference. I have blocks from 39 earliest to latest is a 52 dont see any difference in the holes for water. Hole in the gasket is always larger than the port.
 
Water pump engines had smaller holes in the head gasket since the pump helped move the coolant. Thermosiphon system gasket had large water holes. An old NAPA engine parts book showed the difference, depending if a pump was used or not.
 
I remember the gasket books calling for a head gasket with or without a water pump. Smaller holes with the pump to slow the circulation down to cool better.
 
You must log in or register to reply here.

Similar threads

M
Super C Carb Identification
Replies
4
Views
274
mainer76
M
Sterff89
Super A Pistons
Replies
9
Views
527
Sterff89
Sterff89
N
Super A
2
Replies
26
Views
1K
NHbalerman
N
R
Super C bull pinion gear retaining washers/bolts
Replies
12
Views
344
300guy
3
B
Farmall 340 Engine
Replies
4
Views
372
gene bender
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top