1066 Clutch

Curt 650 · Dec 22, 2013

What"s a ballpark figure to put a clutch in a 1066

kennell · Dec 22, 2013

Are you talking parts and labour or just parts? kent

Nebraska Kirk · Dec 22, 2013

Parts alone will run about $475-500. Labor will depend on who you hire to replace it, but I would say total cost will be in the $1200-1500 range.

fixerupper · Dec 22, 2013

A new clutch put in my 1086 by a dealer this fall was in the $2500 range. Flywheel was turned, new pressure plate, PTO stub shaft replaced, new rear seal and clutch booster seal set installed. Done and back out the door in just a little over a day. Jim

Curt 650 · Dec 22, 2013

Yes Parts and Labor

Ethan Chamberlain · Dec 26, 2013

I am just finishing a clutch job on a 966, and the parts bill for me was around the 825 mark if im thinking correctly. It got a new pressure plate, clutch disk, rear main seal, throwout bearing, IPTO shaft, and all the front transmission seals and O-rings. I had the flywheel ground too, that cost me another $50. So the parts totaled around that 875 mark. Im not real sure on what the labor side would be though

1066 Clutch

Curt 650

New User

kennell

Member

Nebraska Kirk

Well-known Member

fixerupper

Well-known Member

Curt 650

New User

Ethan Chamberlain

Member

Similar threads