farmall H rods

bmartin5566 · Dec 4, 2013

need specs on H rods. sizs at pin&crank plus leanth. going to try to use for allis 17 puller build. may need a set of rods..thanks BOB

Zachary Hoyt · Dec 5, 2013

I have a set of rods if you decide you want a set. They are in the block now but I can pull them over the weekend. Sorry, I don't have measurements.
Zach

super h man · Dec 5, 2013

H rod is slightly narrower than the 17, which is no problem, when they grind the crank they will match up the rods with the journal. H rods are 8in, have seen some at 7.95 but them were not bored right from day one. you have 2 bearing inserts available to fit the h rod. the H, at 2.249 and the 350 which uses a larger diameter journal, but i dont have that exact spec in front of me. depending on what piston you use, in my case, dodge pistons, they use a 1.09 pin, ive reamed the dodge pistons to use H pins and install keeper locks in the pistons. shoot me an email, we have talked before. thanks.

farmall H rods

bmartin5566

Member

Zachary Hoyt

Well-known Member

super h man

Member

Similar threads