(800) 853-2651
SHOP NOW

7230case ih

B

ben brown

Member
7230 case ih pulls like it is under load all the time put inching clutch in and it stops like you push in on the brakes any suggestion
 
If it pulls to one side as it is binding I would say brakes. If it is doing both sides it could be the brake equalizer (If it has one). Do not operate it except for testing. It sould be a frozen bearing in the driveline and driving it would ruin a housing or major cost parts. Jim
 
i should of said both wheel i unhook the brake line sna it still lock up i never have been into one of thees.
 
My 7110 did this many yrs ago...turned out the brake pedals were sticking on ...reach down and pull up on them and see if they release..may just need cleaning and lube..the master clys are located on the firewall ..open hood and they are obvious some spray lube on the linkages work wonders...hope this is your problem.
 
(quoted from post at 18:31:50 11/16/13) My 7110 did this many yrs ago...turned out the brake pedals were sticking on ...reach down and pull up on them and see if they release..may just need cleaning and lube..the master clys are located on the firewall ..open hood and they are obvious some spray lube on the linkages work wonders...hope this is your problem.
Click to expand...

i check brakes has same set up as the 86 series i even took the brake line loose still locks up but think for all the replies i have to get to shop just dig into it one thing at a time
 
(quoted from post at 17:21:04 11/17/13)
(quoted from post at 18:31:50 11/16/13) My 7110 did this many yrs ago...turned out the brake pedals were sticking on ...reach down and pull up on them and see if they release..may just need cleaning and lube..the master clys are located on the firewall ..open hood and they are obvious some spray lube on the linkages work wonders...hope this is your problem.
Click to expand...

i check brakes has same set up as the 86 series i even took the brake line loose still locks up but think for all the replies i have to get to shop just dig into it one thing at a time
Click to expand...

Does it free up with the engine shut off?
 
(quoted from post at 01:34:13 11/18/13)
(quoted from post at 17:21:04 11/17/13)
(quoted from post at 18:31:50 11/16/13) My 7110 did this many yrs ago...turned out the brake pedals were sticking on ...reach down and pull up on them and see if they release..may just need cleaning and lube..the master clys are located on the firewall ..open hood and they are obvious some spray lube on the linkages work wonders...hope this is your problem.
Click to expand...

i check brakes has same set up as the 86 series i even took the brake line loose still locks up but think for all the replies i have to get to shop just dig into it one thing at a time
Click to expand...

Does it free up with the engine shut off?
Click to expand...


you know i don't know for sure but i am like you i still keep going to break problem seem that the ih dealer thinks so to so going to bring it to shop and do some close checking where i can jack it up see if wheel well turn with engine not running well let you all know what i find out
 
You must log in or register to reply here.

Similar threads

C
2840 Clutch Problem
Replies
1
Views
220
grwrench
G
J
IH 154 Cub lo-Boy clutch pressure plate
Replies
2
Views
165
grandpa Love
grandpa Love
R
Gauge question
Replies
6
Views
408
Rich'sToys
R
L
No start after fuel filter change IH 656 Roosa Master
Replies
5
Views
235
Dieseltech
D
G
Case ih D45 Tractor
Replies
0
Views
127
grizz665
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top