706 cab

SgtPresto · Nov 4, 2013

Hello all, I am putting a YaR cab on a farmall 706 and was wondering where to install the heater connections, as well as the correct way to tap into the electricty for the heater fan and lights. Pictures would be helpful!

Thanks

the tractor vet · Nov 4, 2013

Well ya did not say what engine ????? as for the cab power here i get a little fussy , i pull off the starter with a 10 ga. wire to a couple breakers and run a twenty amp breaker for the blower motor on a 12 ga. wire and if your mounting lights on the cab then a twenty amp breaker and a CV relay and a trigger wire from the light switch to the relay .

SgtPresto · Nov 5, 2013

Thanks for responding--

It is a Farmall 706 gas. From what I have read, I am supposed to T into the temp sensor port in the head for the heater "inflow" and connect the heater "outflow" either to the radiator drain or a port on the right side of the water pump.

For lighting, I have 2 lights in the front and 2 lights in the back with a total draw of probably about 18 amps. What should my controlling relay be rated at for continous duty? Also, What is meant by "cv" relay----coil voltage? I aim to put 20amp inline fuses, but I am not sure what you mean by breakers?

Thanks!

706 cab

SgtPresto

New User

the tractor vet

Well-known Member

SgtPresto

New User

Similar threads