Global Warmer
Member
I"m trying to pull my injectors out of my 560 and they don"t seem to be havin it. Any tips on pulling them.?
- Thread starter Global Warmer
- Start date
rustred
Well-known Member
i just use a lady's slipper bar and just pry up the sticky ones. most time they just come out by hand. this proves that the seal rings and dust rings are doing their job.but if you have compression leaking then that carbon can really make them stick. for the precups there is a puller but thats an ih item and didnt have to use one yet. you could squirt some gunk carb cleaner in the bore and that will loosen them also as it dissolves the carbon.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy