Hey guys, a "W" series guy in need of some help. I going thru my Dad's new to him Farmall H. Figured the front wheel bearings would like some TLC. Took apart, it was in need of new grease. One side the seal was broken right in half. Not sure how a seal can break right in half. Anyways, clean the spindles up, hubs, bearings. Ordered front seals from local IH dealer. I got part number 48539DA from them. It seems like this seal will drive onto the spindle, then the hub goes over it. It seems abit loose, is that the way its suppose to be? Its a lot different front end then a good old W series tractor that I'm used to. Thanks for any help, Scott.