(800) 853-2651
SHOP NOW

IH 2 Bottom Plow

M

Marion Watts

New User
Hello forum members. I'm new around here and this is my first post.

I acquired a quick hitch two bottom plow. I'd like to rebuild it this winter. I'm not sure about getting the correct mold boards, share, slides, etc... and need some guidance.

The plows have part #'s 520722R1 & 520723R1 stamped on them.

What plow do I have and where can I obtain rebuild parts?
 
Is it for a SC through 230, that is does it have the smaller 2 point prongs? Does it have a single large impact spring on the top? How many plows? Are the plow shares 14, 16, or 18-inch?
 
Never heard of that restriction on photos but I could be wrong. Start by clicking Add a Reply then try clicking the link at the bottom of the reply which reads "Advanced Posting Options" and follow the steps to upload a photo loaded on your computer.
 

LMack, it's a single quick hitch. No spring. I'm not sure if its 14 or 16"

I followed the steps you stated on posting a pic. I'll try again.
 
Lots of luck getting new moldboards what is wrong with the ones on the plow now they can be shined up as getting new ones can be a mess getting them to scour. Dont try and plow deep to scour them. Are the points two piece or just one.
 
mvphoto296.jpg
 
You have a one point 2-14 plow with "Plow Chief" shares for a 100 through 140 (if I see the photo clearly). The points can be found but they are scarce. If you wish to replace the plows you will be forced to use a more modern version called "Super Chief" and they are pricy. Your plows are two piece with a solid wing and point and no shim. The "Super Chief" version will have a three piece set up and will include a one piece plow point as well as a shim. They will bolt right onto your frame replacing your existing plows and wear parts are readily available.
 
All bets are off then. If you have a three piece share it is a "Super Chief". If a two piece share it would be a "Plow Chief". Do you have one hitch point or two? What kind of tractor will it fit?
 
You must log in or register to reply here.

Similar threads

L
Lill Genius 2 Bottom or 3 Bottom Parts plow
Replies
11
Views
1K
Olyj1947
O
M
two bottom IH trailer plow question
Replies
15
Views
2K
gene bender
G
K
Ferguson 14A 2 bottom Plow Parts
Replies
17
Views
2K
Leroy
L
L
IH Little Genius trip plow problem
Replies
3
Views
560
Mike(NEOhio)
M
P
Seeking knowledge on my (1962?) Ford Industrial Backhoe/
Replies
4
Views
997
PlowboyJim
P
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top