(800) 853-2651
SHOP NOW

bull pinion shaft bearing

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

M

matt51farmall

New User
I am changing bull piniin shaft bearing. The one I removed had st227 on bearing. 15 balls in it. The one napa got in was there part number and it had only 10 balls. Same dimensions. Does any One know what new part number is so I can get a high capacity bearing with 15 balls to replace it with. My book shows. St269 but I dont know if it is high capacity. Thanks. Matt
 
The number should cross at Motion Industries. A full complement bearing is desirable. do not accept a lesser bearng. A
 
I am sure it is. All IH tractor bearings are metric and usually very common numbers. Do not accept a Bearing from China. They just do not do it right for export. Japaneese and Korean (as well as US and European bearings are great. Jim
 
(quoted from post at 20:29:38 09/29/13) I am sure it is. All IH tractor bearings are metric and usually very common numbers. Do not accept a Bearing from China. They just do not do it right for export. Japaneese and Korean (as well as US and European bearings are great. Jim
Click to expand...

You seriously think he could wear out a China bearing that was properly cared for?
 
If care means running it with the rear wheels off the ground doing belt work, or PTO work, They might last 6 months. Jim
 
(quoted from post at 08:29:01 09/30/13) If care means running it with the rear wheels off the ground doing belt work, or PTO work, They might last 6 months. Jim
Click to expand...

They run in an oil bath and barely turn. I doubt they would be that inferior. I have seen what comes out of the rear end of a tractor that appears to be fully functioning on the exterior.
 
You must log in or register to reply here.

Similar threads

J
IH 154 PTO shaft bearing
Replies
0
Views
70
John in Ct
J
D
bull pinion bearing replacement
Replies
8
Views
337
DD in WA
D
R
Super C clutch pilot bearing
Replies
7
Views
429
Roger46
R
M
821 w/4 speed input shaft load bearing snap ring?
Replies
4
Views
178
pomester
P
T
bearing for steering shaft MF65
Replies
0
Views
101
tntractor
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top