(800) 853-2651
SHOP NOW

IH, F4 Magneto

B

Bill in NJ

Member
Working on an IH F4 magneto. I need to replace a
couple of the flip top oilers. Does anyone sell
them? How does one go about removing the old one and
inserting the new one? They appear to be soldered
into the casting. I'm afraid to heat them in fear
that the flip top, which is also soldered on, will
break away. Grateful for any info. Thanks. Bill
 
They are press-fit. I have removed and replaced them by opening the cap and pulling them out with a needle-nosed pliers.

My source is a parts mag.
 
Type in Magneto on your computer and you wiil find a number of rebuilders. Callsome of them they should be able to help you.
 
Frequently they will tear if you try to pull them with needle nose pliers. I have found a better way, open the lid and insert the back end of a snugly fitting drill bit or a punch. Grab the outside of the body with pliers pinching the drill bit, twist and remove.

To insert the new one mount the new oiler on the end of the bit and tap the end of bit or punch. This will put the stress on the taper at the bottom instead of tapping on the lid and possibly deforming the oiler.
 
You must log in or register to reply here.

Similar threads

D
IH 3514 Diesel Clutch Replacement (Bacckhoe)
Replies
4
Views
419
used red MN
U
W
IH 574 diesel fuel pump leak
Replies
3
Views
350
Dieseltech
D
N
F4 magneto
2
Replies
25
Views
4K
Nxslt1
N
D
IH 300U Carb
Replies
2
Views
242
D Slater
D
super99
super88 update
Replies
14
Views
790
GermantownGreen
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top