Double bevel rim

MoCoJo · Sep 19, 2013

What's the easiest way to put these wheels on the cast centers
if you are working alone?

David G · Sep 19, 2013

I put a strap around the rim/tire and hold it up with hoist.

farmallboy15 · Sep 19, 2013

spud bar.

Pete_5959 · Sep 19, 2013

I just put mine on a few weeks back by myself. Had centers on axle with bolts and back clamps installed. Rolled rim and tire onto a small wheeled furn dolly. Pneumatic bottle jack under the axle being serviced. Just rolled wheels right into the hub centers with the jack putting the centers at the correct height. This method made short work of installing.

dej(Jed) · Sep 20, 2013

Turn the cast center up and put on 3 lugs on losely. Lower the center and roll the rim onto the 3 lugs. Jack it back up. Snug up the top 3 lugs. next go right or left adding lugs and snugging as yo go. The trick is in the inital alignment. It isn't as easy as an M or H, but it isn't to awful bad.

mkirsch · Sep 20, 2013

I've heard it done by installing two lugs 90 degrees apart. Then you set the rim on those lugs, aligning the bumps in the rim to the lugs. Work around from there.

Double bevel rim

MoCoJo

New User

David G

Well-known Member

farmallboy15

Member

Pete_5959

Member

dej(Jed)

Well-known Member

mkirsch

Well-known Member

Similar threads