(800) 853-2651
SHOP NOW

1066 Noisy Transmission

W

Wicksfield

Member
I have a 1066 with a transmission that really whines when the TA is in the high range forward position. When pulled into low range, it"s not near as noisy. Is there something wrong, adjustment to be made, or are these tractors inherently noisy?
 
My 1256 whines in LOW ta ever since I replaced it 5 years/1000 hrs ago.My other tractors are 'quiet' on both sides.
 
Could be cause by not having the t/a shimmed and the lower counter shaft gear not shimmed to match or the lower counter shaft was set to tight or to loose . Lot of guys think that ya just STUFF a rebuilt t/a in and bolt her down and stuff it together . Yep it will work but it ain't wright.
 
I set my TA with a dial indicator as per the book.I have often wondered if I 'messed up'.But it works as it should so I dont worry...
 
Did you have to add any shims'' behind the quill?? If you did then did you shim the gear on the lower countour shaft with the same shim ?? did you tighten up the countour shaft nut tight then back off then re SNUG and drill the nut and install the 1/8th inch roll pin??
 
You must log in or register to reply here.

Similar threads

G
knocking noise in transmission
Replies
1
Views
152
chris142
C
S
Best Practices for IH Wet Sleeve Engines (886, 986, 1066, etc.)
Replies
16
Views
866
JIM MN
J
L
806 Range selector quit engaging today
Replies
8
Views
495
Luther D
L
D
830 CK hydraulic issues. And power steering problem
Replies
9
Views
482
Danny Hogge
D
K
300 gear noise
Replies
4
Views
290
r.w.b.
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top