(800) 853-2651
SHOP NOW

MW hand clutch question

C

Chris Klein

Member
I found a hand clutch off of a 45 M but I am not
sure if it is complete. My question is what all
parts would have come with it when bought new ?
Thanks
Chris
 
I deal in M&W hand clutches and parts. If you can post some pictures here or send them to me via email: [email protected] I can then determine if your clutch is complete or in need of additional parts.
 
I can not do pictures right now. What I really
need to know is I have the bull gear shaft that
the brake drum goes on. The shaft was pulled from
the trans but my real question is everything from
that point back into the trans the same ? I got
the clutch from a local scrap yard and the rest of
the trans will go in his roll off tomorrow. He
pulled it out and I know I have everything from
the bull gear shaft out but he did not pull the
bull gears and I would like to be sure I dont need
anythingelse before he scraps whats left
Thanks
Chris
 
Kirk,

I am getting ready to do a M that has a really tight M&W hand clutch. I will get you pictures when I get back home, but could you fill me in on if there are different ones? Are they manuals for them? How are these to rebuild? How much does it cost?

Matt

[email protected]
 
(quoted from post at 18:55:04 08/05/13) I can not do pictures right now. What I really
need to know is I have the bull gear shaft that
the brake drum goes on. The shaft was pulled from
the trans but my real question is everything from
that point back into the trans the same ? I got
the clutch from a local scrap yard and the rest of
the trans will go in his roll off tomorrow. He
pulled it out and I know I have everything from
the bull gear shaft out but he did not pull the
bull gears and I would like to be sure I dont need
anythingelse before he scraps whats left
Thanks
Chris
Click to expand...

In that case you do NOT have all the parts!! STOP THE TRUCK!! The special hollow M&W pinion gear is still inside the case!
 

Why not just get the rest of the rear end??

There are parts on the right side brake you need also
 
You must log in or register to reply here.

Similar threads

3
MW Clutch - Super M
Replies
16
Views
628
DeltaRed
D
M
W6 Hydraulics.
Replies
8
Views
342
Masseyharrisnut
M
D
Farmall 300 clutch trouble
2 3 4
Replies
76
Views
1K
Mrfred54
M
D
Farmall 300 clutch update
Replies
4
Views
222
used red MN
U
R
Farmall bn final drive making noise and jumping around
Replies
8
Views
307
grandpa Love
grandpa Love
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top