(800) 853-2651
SHOP NOW

What size overrunning clutch for an H

Y

Yooper Farmall

Member
I"m looking at getting a 5" 3pt brush hog for my Farmall H. Its an "41 with the smaller/older style PTO shaft. What size overrun clutch do I need, I see Tractor Supply has a Female spline 1-1/8" x 6". Male Spline 1-3/8" x 6". Fits all W/1-3/8" PTO shafts. This the one I need?
 
There is only two sizes of PTO shafts that are the 540RPM. The smaller is 1-1/8 and the new standard is 1-3/8 so you need the 1-1/8 to 1-3/8 but there are 2 different ones one fits the Farmall type and one the ford type shafts. Learned that the hard way
 
I would go with a 5' (5 foot mower) on an h unless you will be mostly mowing little stuff or your h is exceptionally strong in the motor soup up dept (e.g. super h pistons installed).

A 5' (5 footer) is all my plain ole h wants in heavy stuff and even then I may not be able to take a full swath.

I believe the too small comments were good natured teasing result of your 5" typing (which equals 5 inches).
 
I"ll go with a 5 foot because they are very common around
here and easy to find used, plus easier to trailer. I"ll be cutting
small clearings at 2 track roads so smaller will be more
maneuverable. We did use super H stepped and bored
pistons, but some of the weeds can get 3 feet tall. I did type 5
foot but for some reason this site always changes my hash
mark to a quote. Thanks for all the advice, I will check the
brush hog for a built in clutch before I purchase.
 
You must log in or register to reply here.

Similar threads

S
JD H PTO / Power Shaft replacement
Replies
5
Views
528
sc4ram
S
gears
3400 clutch advise
Replies
8
Views
514
gears
gears
Stroby
1959 John Deere 430W
Replies
8
Views
421
Jim.ME
J
D
Hydraulic pump driveshaft for loader
Replies
1
Views
990
ptfarmer
ptfarmer
C
MF Power Steering
Replies
1
Views
610
Mduncan60
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top