'H' Clutch Adjustment Rod

FBH44 · Jul 16, 2013

Whenever I adjust the clutch adjustment rod so the pedal shaft is 1" away from the transmission cover, there is one thread left in the threaded end. Other words, the rod bears on only one thread. It works, the clutch works OK< but what is happening? Why only one thread left?

rustyfarmall · Jul 16, 2013

Time for a new clutch and pressure plate.

dej(Jed) · Jul 16, 2013

It means you will need a new clutch soon.

gene bender · Jul 16, 2013

better be replacing some parts starting with throw-out bearing then pressure plate and disc. Your linkage probably is also shot too much play.

Owen Aaland · Jul 16, 2013

When a clutch disk wears the release fingers move away from the disk resulting is less free travel. In this case you have too much free travel not too little. That would indicate a problem with the linkage, release bearing, or the release levers. Most likely the disk and pressure plate are still fine unless the problem is with the release levers.

Janicholson · Jul 16, 2013

The bolts that hold the throwout fork to the shaft (inside) can wear and begin to shear. replacing them can be done pretty easily by removing only the Belly pump (if equipped). Either way the problem is easier to find when you can see it. Jim

'H' Clutch Adjustment Rod

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

FBH44

Well-known Member

rustyfarmall

Well-known Member

dej(Jed)

Well-known Member

gene bender

Well-known Member

Owen Aaland

Well-known Member

Janicholson

Well-known Member

Similar threads