(800) 853-2651
SHOP NOW

dual clutch question

N

not8n

New User
I have an IH 354 with a dual clutch. Should be same as 444. There was a post on how to adjust this clutch thru the access hole in the bottom of the tractor. Can anyone re-locate this post or tell me how to do this from the access hole?

I tried a search but came up empty. My clutch is not working for the PTO. The PTO is either on all the time or off. Clutching all the way down has no effect on the PTO at all. Thanks js
 
Hi JS,
Hopefully your PTO clutch is not seized to the
pressure plate. First do clutch foot pedal
adjustment.

There is an adjusting screws on each clutch
finger. As I posted before on our 434 the
adjusting nuts on these screws ware a grove in the
pressure plate fingers and this caused the type of
PTO problems you are experiencing. By loosening
the adjusting nuts and turning them a 1/4 turn so
they would not rest in the old worn groove fixed
our 434 PTO problems.

JimB

Here is link to archives:
http://search.yesterdaystractors.com/cgi-
bin/viewit.cgi?bd=farmall&th=888950
 
A couple of yrs. ago I too purchased a 354. It had
been sitting for several yrs. It too had the clutch
stuck. with someone holding the petal down I struck
the disk with a prybar and hammer several times
through the inspection hole in the bottom and it
broke loose and works fine. good luck.
 
(quoted from post at 18:26:48 09/08/13) A couple of yrs. ago I too purchased a 354. It had
been sitting for several yrs. It too had the clutch
stuck. with someone holding the petal down I struck
the disk with a prybar and hammer several times
through the inspection hole in the bottom and it
broke loose and works fine. good luck.
Click to expand...
 
I don't know why it did that! I just wanted to say thanks for the replies. I'll try the pry bar and hammer method.
 
You must log in or register to reply here.

Similar threads

D
Farmall 300 clutch trouble
2 3 4
Replies
76
Views
1K
Mrfred54
M
B
John Deere 2020 PTO Clutch Adjustment
Replies
13
Views
596
Tx Jim
Tx Jim
L
PTO suddenly grinding
Replies
8
Views
317
Destroked 450
Destroked 450
D
Ford 3000 Clutch issues
2
Replies
20
Views
868
Btzj02
Btzj02
J
TO35 pto clutch or clutch shaft?
Replies
2
Views
159
John Deere D
John Deere D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top