Sloppy Shifter Fix

CTPhil · Jun 11, 2013

Does anyone know anything about this?

http://www.ebay.com/itm/370824388156?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

charlespretzer · Jun 11, 2013

Just put one in my farmall H. Works good. Had to build up the end of the shifter lever.

Zachary Hoyt · Jun 11, 2013

I put one in my Farmall 300 last summer and it made a world of
difference. Because the 300 shifter is bent to the left at the top I
had a hard time finding gears with the old pin because the shifter
would twist about 45 degrees when I tried to push or pull. With the
new pin it has virtually no twist and I know exactly where I am.
Zach

FBH44 · Jun 11, 2013

Yep, works great.

Haas · Jun 11, 2013

Put one in my I-6 after it locked up in two gears. It took all the
play out of the gear shift. Works great! Highly recommended.

Stumpy(NH) · Jun 11, 2013

Yup, sure do. Installed it on my '48M. 400% better as compared to the bolt someone had put in it! Nice kit, good craftsmanship...going to buy another kit for my H just because.

Very highly recommended

Stumpy

CTPhil · Jun 11, 2013

Do you have to drill the holes out?

Stumpy(NH) · Jun 12, 2013

Nope, just remove the shifter, install the sleeve, then put the pin through and tighten down. I did have to remove the three bolts that hold the steering shaft support to get room for an allen wrench on one side though.

Piece of cake

Stumpy

CTPhil · Jun 12, 2013

Thanks! I think I'll get one for my brand new to me 560!

Sloppy Shifter Fix

CTPhil

Member

charlespretzer

Member

Zachary Hoyt

Well-known Member

FBH44

Well-known Member

Haas

Well-known Member

Stumpy(NH)

Member

CTPhil

Member

Stumpy(NH)

Member

CTPhil

Member

Similar threads