1066

trailrider82 · Jun 2, 2013

I was raking hay, so was only running about 1600 rpm and when I was turning riding the brake the red light came on and it was acting like you was engaging the clutch and releasing it. Would that be the hydraulic filter?

T in NE · Jun 2, 2013

Could be. Or low on fluid, or the O-ring in the suction tube is bad. Or the MCV or TA has a problem.

Janicholson · Jun 2, 2013

Over fill the system by 5 gallons of hytran. it hurts nothing, and covers a possibly bad Oring on the MCV pump intake. Jim

the tractor vet · Jun 3, 2013

While turning and usen the brake tells me of low MCV pump output .or like others have said low oil level . If this happened while going down hill then i will go along with a low oil level . if you were on flat ground then pump output , a sticking flow divider , internal leakage in the T/A , dirty hyd filter . Check the easy stuff first change the filter and check oil level. And if needed then add a couple gallon more oil. Then if all this does not FIX the problem then get your PIGGY BANK out .

trailrider82 · Jun 3, 2013

Thanks for all the info. Changed filter and added 2 1/2 gallon and it fixed it. I had just put both pumps in new in the last year, so I was hoping it wasn't that.

Janicholson · Jun 4, 2013

Good deal.(and inexpensive!) Five gallons over the full mark is Standard Operating Procedure! Jim

1066

trailrider82

New User

T in NE

Well-known Member

Janicholson

Well-known Member

the tractor vet

Well-known Member

trailrider82

New User

Janicholson

Well-known Member

Similar threads