throttle bushings in M carb

nateinia · May 25, 2013

What is a good way to get these bushings out? Seems like they are driven in to a stop.

pete 23 · May 25, 2013

I tap them and screw the slide hammer in to pull them out. You can just turn in a self tapping bolt, rat tail file or various other techniques and go through from other side and drive them out. Should take only one at a time and then run reamer in from other side to keep proper alignment. Also, the bushing on governor side has an alignment slot for the two holes that go to economizer circuit. I always shorten that bushing before installing as it requires a special tool to cut it off after installation otherwise. It is supposed to be 5/8th inch in I believe. Other ways of doing it of course just my method.

throttle bushings in M carb

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

nateinia

Member

pete 23

Well-known Member

Similar threads